keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about B100/200/400/800 ISDN BRI Cards

easy way to install OpenVox B100-B200-B400p in trixbox-2.6!

15 years 6 months ago #2168 by davidrhysthomas
Hi
Some progress at last
I uninstalled mISDN from GUI then reinstalled with yum
ran mISDN and now can run misdn show stacks this says L2link down L1link up though once it said both were up
Incoming calls now work but not outgoing
rings out then eventually announcement to hangup and try again later
Could this line be significant
P[ 1] channel with stid:0 for one second still in use!
-- Called 1/outnum
Thanks in advance
15 years 6 months ago #2169 by davidrhysthomas
Hi
It would appear that the outgoing call is going out and i get a tone which is then replaced by a BT (telecom provider) message saying "Please hang up and try later" this is then replaced by a trixbox voice saying "all circuits are busy"
15 years 6 months ago #2178 by davidrhysthomas
Hi
Still no joy with outgoing calls it looks like the call can not be completed after it starts is %outnum$ wrong it does not seem to be looking at the output when a call starts.
Getting a bit desperate now. I had outgoing calls on sunday using the procedure of the trixbox wiki why not now? something to do with msidn.conf?
15 years 6 months ago #2179 by davidrhysthomas
Hi
Further to this problem. It appears that the when a call is dialed the outside line isopened but no number is dialled (this also applies to speed dials) but if while the dial tone is heard i dial the number on the phone keypad then the number is connected?
Help
15 years 6 months ago #2180 by james.zhu
hello:
can you please the outgoing calling in this way:
1) create a SIP extension with a context called from-test
2) add dialplan in extrensions:
[from-test]
exten => 10000,1,Dial(your ISDN port/your destination number)
exten => 10000,2,Hangup
here, make sure your ISDN port is working port.
regards!
James.zhu

15 years 6 months ago #2204 by lakesideit
Done the instructions as per instructions.

I can dial out but when dialling the number I get "all circuits are busy"

Any help is extremnely greatful.

Cheers

Ashley
Time to create page: 0.039 seconds
Powered by Kunena Forum