keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about B100/200/400/800 ISDN BRI Cards

B100P and mISND v2

11 years 8 months ago #8316 by mourkousis
I am trying to build a CentOS 6 server with asterisk 1.8 and a B100P card. I have installed the OS (kernel 2.6.32-279.5.2.el6.x86_64) and it seemes to have mISDN version 2. The problem is that the OS does not have commands misdn-init or mISDN (in order to perform scan and conhfig command as executed in the manuals) available.In the wiki I could not find instructions for B100P and mISDN v2. Is it possible to install the B100P with mISDN v2 or I have to switch to mISDN v1?
In manuals for B200P and B400P and mISDN v2 (e.g. http://wiki.openvox.cn/index.php/OpenVox_B200P_User_Manual_for_mISDN%28v2%29 ) there is a step 3 where a patch must be made and the kernel to be compliled.
The link for the file mentioned ( http://www.openvox.cn/viewvc/misdn/trunk/mISDN_2.0/hfcmulti.c?view=log ) is dead.
Could anyone you provide information on how to execute these two steps (patch mISDN and compile kernel)?
Thank you in advance.

i] Last edited by mourkousis at 2012-9-3 02:15 [/i
11 years 8 months ago #8317 by chunlei.yi
hi,
plese refer to the following link to install misdn, if still have problem,please contact me via msn or skype.i think you can use dahdi drive to try, it may be a better choice
wiki.openvox.cn/index.php/OpenVox_B100P_User_Manual_for_mISDN

msn: This email address is being protected from spambots. You need JavaScript enabled to view it.
skype: chunlei.yi
Time to create page: 0.028 seconds
Powered by Kunena Forum