keywords: ip pbx voip gateway gsm gateway

×

Notice

The forum is in read only mode.
× Questions about B100/200/400/800 ISDN BRI Cards

B100e And Bt

10 years 9 months ago #9036 by kierank
Hi I am having a lot of trouble trying to get this card to work making an outbound call. I am using freepbx 2.11 and asterisk 1.8.I have installed the dahdi module and it shows
Cologne Chips - HFC-S PCI A ISDN card 0 [TE] [1]OKCCS/AMI3/33bri_cpe
In the freepbx cli if I issue the command dahdi show status i get
HFC-S PCI A ISDN card 0 [TE] OK 0 0 0 CCS AMI 0 db (CSU)/0-133 feet (DSX-1)If I issue the command dahdi show channels I get Chan Extension Context Language MOH Interpret Blocked State pseudo default default In Service 1 from-digital en default In Service 2 from-digital en default In ServiceI have setup a trunk and also an outbound route, however no matter what I change I cannot seem to make an outbound call. I am using this with a BT Isdn bri line.Please help if you can.
10 years 9 months ago #9037 by kierank
Not sure if this will help but I see this in the asterisk cli.
-- Executing [continue@macro-dialout-trunk:1] NoOp("SIP/701-00000003", "TRUNK Dial failed due to CHANUNAVAIL HANGUPCAUSE: 1 - failing through to other trunks") in new stack
-- Executing [continue@macro-dialout-trunk:2] Set("SIP/701-00000003", "CALLERID(number)=701") in new stack
-- Executing [0035316272921@from-internal:6] Macro("SIP/701-00000003", "outisbusy,") in new stack
10 years 9 months ago #9038 by hua
HI

Please show me the output of "pri show spans" .Add my Skype upper.hua .

Best regards
upper.hua
10 years 9 months ago #9039 by kierank
thanks,the responce to pri show spans is [align=center]PRI span 1/0: Up, Active [/align]
[align=center]I have added you on skype what timezone are you in. [/align]
Time to create page: 0.037 seconds
Powered by Kunena Forum