Need help for B200M

We ordered a B200M and PFM100 last month.

We have a NT1 from our telephone provider. I have installed the mini PCI card on the alix 3C board.
When I use the askozia software I can see that the card is recognized by the software. It gives 4 isdn interface.
When I connect the cable from the NT1 to the B200M No light go on. When I try to make a call to our isdn line. I get no signal.
I searched the documentation on the website and put the jumpers in the position for NT (network termination)
I tried with and without the power supply. Don't get any signal.

The cable I used is a 4 wire ISDN cable. I also tried a standard cat5 utp cable but no result.

Do you have some support?
Best regards,

Wim Van Clapdurp
TCS Computers BVBA
url: www.tcs-computers.be
This email address is being protected from spambots. You need JavaScript enabled to view it.

hello,
i think the isdn4bsd in askozia can not support our B200M well. the version of isdn4bsd must be updated. svn version of isdn4bsd has supported B200M.
regards!
james.zhu

What software can I use ?

The alix board and the b200m cannot be changed the askozia software can.
Is there a software package wich works with the b200m and the alix 3c board?

Best regards,

Wim Van Clapdurp

hello,
you can try voyage-linux, but you have to do many things for working system.
please check from:
openvox.com.cn/downloadsFile/ix100_Alix2c2_voyage-linux.pdf
regards!
James.zhu

When I connect my B200M with the isdn equipement from my provider.
Should the led lights light up?

Should one of the leds work?
I'm in Belgium How to figure out I have TE or NT??

Best regards

hello,
i think you have to set the ISDN from GUI. you can refer this:
forums.digium.com/viewtopic.php?p=67426&...1d46116b40176881bf47 .
regards!
James.zhu