keywords: ip pbx voip gateway gsm gateway



The forum is in read only mode.
× Questions about D130/230/430/830/1630 Advanced T1/E1/J1 PRI Cards

Two D230E cards causing random system reboot on FreeBSD 9.2

10 years 8 months ago #9129 by dondos

My production server setup is:
- FreeBSD 9.2 x64
- Gigabyte B75-D3V
- Intel Core i3-3240 CPU
- 500W Sirtec PSU
- 2x 4GB DDR3 Corsair RAM
- 2x 1TB WD HDD
- 2x Openvox D230E card
- Asterisk
- dahdi 2.6.1 (installed from FreeBSD ports)
- 2x OpenVox D230E cards
- three E1 link with three different telecom providers

My test server has a different mobo (Gigabyte P61A-D3). The other system components are the same make/model as above.

The problem:

For about a week or two my production server setup worked flawlessly. But starting two days ago it began acting funny:
- spans won't sync until system is restarted (span stays in RED/REC alarm)
- system reboots unexpectedly after 5-40 calls received (with no kernel panic or crash dumps)
- random incoming calls get disconnected with hangup cause 27

Thinking that maybe there is some kind of hardware problem with my server i moved the cards in my test server. Same problems with this setup, also.
Additional info:
- I don't use a timing cable (do I need to use one? I am using the cards ONLY for voice service).
- I configured the cards for E1 (using the interface select jumpers)
- I configured the cards to 0 and 1 using the card serial number select
- one card is using irq16 the other irq17

Where sould I start ?

i] Last edited by dondos at 2013-10-15 00:16 [/i
10 years 8 months ago #9132 by chunlei.yi

i need to check it remotely, pls contact me on skype when you are online.

skype: chunlei.yi
10 years 8 months ago #9136 by dondos
Ok, I left you a message on skype.
Thank you.
10 years 8 months ago #9140 by chunlei.yi

sorry, i don't receive the message, which timezone are you in, i am in utc+8
10 years 8 months ago #9143 by dondos
I need to get this server running ASAP so I switched to Debian.
I'll get back to you if I'll run into the same problem again.

Thank you,
PS: my timezone is UTC+2.
10 years 8 months ago #9144 by chunlei.yi

ok,pls try agian, if still have problem, contact me freely.
Time to create page: 0.036 seconds
Powered by Kunena Forum